Influence of SiO2 in SiCp on the microstructure and impact strength of Al/SiCp composites fabricated by pressureless infiltration

The effect of SiO₂ in SiC_p and the following processing parameters on the microstructure and impact strength of Al/SiC_p composites fabricated by pressureless infiltration was investigated: Mg content in the aluminum alloy, SiC particle size, and holding time. Preforms of SiC_p in the form of rectangular bars (10 × 1 × 1 cm) were infiltrated at 1150°C in an argon→nitrogen atmosphere for 45 and 60 min by utilizing two aluminum alloys (Al-6 Mg-11 Si and Al-9 Mg-11 Si, wt.%). The results obtained show that the presence of SiO₂ in SiC affects the microstructure and impact strength of the composites significantly. When Al₄C₃ is formed, the impact strength decreases. However, a high proportion of SiC to SiO₂ limits the formation of the unwanted Al₄C₃ phase in the composites. Also, a higher content of Mg in the Al alloy lowers the residual porosity and, consequently, increases the composite strength. The impact strength grows with decrease in SiC particle size and increases considerably when the residual porosity is less than 1%. Russian translation published in Mekhanika Kompozitnykh Materialov, Vol. 42, No. 3, pp. 401–418, May–June, 2006.     

Experimental identification of physical parameters of fluid-filled pipes using acoustical signal processing

A method is formulated for the identification of an unknown physical parameter of a fluid-filled pipe using the measurement of sound speed in the pipe. The method uses a simple formula which provides the relationship between the sound speed and a few physical parameters of the pipe: thickness, diameter, wall material constants and fluid constants. Once the sound speed in the pipe is measured, the simple formula can be used to extract one of the unknown parameters providing the remaining ones are known.The sound speed in the pipe is measured using a 3-transducer array. In order to demonstrate the potential of the technique the results of several measurements obtained in a water-filled steel pipe are presented.The required accuracy of the measurement of sound speed and of the specification of known parameters is analysed. The accuracy depends on the unknown parameter which is to be identified. For example, if the pipe thickness is the unknown parameter, the other parameters have to be known within a very narrow margin of error. On the contrary, if the fluid properties have to be identified the needed accuracy of known parameters gets much lower.     

A Numerical Calculation for Electron Impact Excitation of Copper

The scattering of electrons by atomic copper has been studied using Born approximation and the concept of the generalized oscillator strength (GOS). Differential and total cross-sections for the excitation of the 3d¹⁰ 4p² P state are calculated at incident energies of 100 eV and are compared with other available experimental and theoretical data. The agreement between our calculation for the differential cross-section and the available experimental results is fairly good at the forward angles, while the agreement at large angles is poor. The calculated total cross-sections are compared with the experimental data and those predicted by several theories. It is found that our calculation for the total cross-sections are in a good agreement with the close coupling calculation of Msezane and Henry (1986a, Physical Review A 33, 1631) for incident energies greater than 20 eV. The integrated cross-section measurements of Ismail and Teubner (1995, Journal of Physics B: Atomic, Molecular and Optical Physics 28, 4164) are in good agreement with the present calculation.     

玻璃的冲击损伤

冲蚀过程是一个与颗粒反复冲击物体表面而移除物质相关的表面现象．本文研究了玻璃的冲蚀坑的几何尺寸和体积，给出了冲蚀移除物质如何依赖于颗粒流动速度、颗粒尺寸和冲击角的理论关系．通过理论与实验结果相比较，定义了一定冲蚀坑尺度的有效域．     

侵彻环境下两种钨合金的细观响应特性

本文实验发现具有较大密度和较高速度的93W钨合金长杆模拟弹的穿靶深度反而比密度较小，速度较低的90W钨合金长杆弹的穿靶深度小．针对这一现象，本文从两种材料在侵彻环境下的细观响应特性的差异上给出了有实验根据的合理分析，结论是90W在侵彻环境下较易于形成绝热剪切带，从而在弹头部发生“自锐化”效应所致．     

Infinite propagation speed of the Camassa-Holm equation

We use the inverse scattering transform to show that a solution of the Camassa-Holm equation is identically zero whenever it vanishes on two horizontal half-lines in the x-t space. In particular, a solution that has compact support at two different times vanishes everywhere, proving that the Camassa-Holm equation has infinite propagation speed.     

On the Use of the Restitution Condition in Flexible Body Dynamics

The difference between the classical treatment offlexible body impact and the treatment of impact in flexiblemultibody dynamics is due to several fundamental reasons. Inthe classical impact theory, simple structures such as beamsand plates are used. Infinite dimensional models can bedeveloped for these simple structural elements to study theimpact dynamics and the wave propagation problem. Flexiblemultibody impact problems, on the other hand, involve bodieswith complex geometry that cannot be modeled using infinitenumber of degrees of freedom. Furthermore, the classicalimpact theory has been mainly concerned with the impactbetween a rigid mass that moves without constraints beforeit impacts a simple flexible structure. This is not amultibody simulation scenario in which the impact occursbetween kinematically constrained bodies that are subjectedto impulsive constraint forces in addition to the impactforces. These constraint forces can influence the motion ofthe two bodies immediately after impact, and as aconsequence, the simple classical theory scenario of impactdoes not apply. It is the objective of this paper to discussthe use of the restitution condition in flexible multibodyimpact problems and demonstrate that the use of thisapproach does not exclude the classical formulation.Nonetheless, the impulse momentum balance approach can serveas an effective and efficient procedure for solving theimpact problem in finite dimensional models that do not obeythe classical wave theory. Energy results of simplestructural elements are presented in order to demonstratethe consistency of using the impulse momentum balanceapproach in solving impact problems in finite dimensionalflexible body applications.     

Refraction of light in media

The roles of the magnetic field and electric field of the light are investigated when the light is refracted in the medium. The model of the electron cloud conductor is presented. Electron cloud in a molecule is treated as a conductor and the Faraday’s Law is applied to this conductor that is in the alternating magnetic field of the light. dB _M/dt of the light gives rise to an alternating induced current on the electron cloud conductor, and the light exchanges energy, i.e. the refractive energy, with the electron cloud conductor. Formulas of refractive index, which is the ratio of light speed in vacuum to that in the medium, are derived with this model. These formulas are tested with several mediums and Langevin’s diamagnetic susceptibility of helium gas, and the results are in good agreement with the measured data. The anisotropy and the nonlinearity of the refractive index are explained with the theory described in this work. Supported by Beijing Science and Technology New Star Program (Grant No. 952870400), the Beijing Municipal Commission of Education and the Excellent Young Teachers Program of Ministry of Education of China     

抽真空获取1.8K超流氦方案分析以及真空泵抽速的预测

低温地面支持系统(CGSE)是专为AMS-02国际合作科学实验项目开发研究的低温地面支持和冷却系统,该系统要完成将AMS-02超导磁体从环境温度到1.8K的冷却过程,超流氦(HeII)的获得是其重要环节。文中针对抽真空获取HeII的方案进行了比较详细的分析和计算,同时针对此方案给出了其物理过程的T-s图、流程简图和实现该过程的主要设备。最后针对此方案,对真空泵抽速进行了预测,这将对后续阶段真空泵的选型具有指导意义。     

牛顿碰撞球的解释与分析

对牛顿碰撞球的常规碰撞形式和混合联珠单球碰撞形式做了理论分析和解释.在常规碰撞时,将悬线(钓鱼线)先悬挂小球一段时间后组装仪器,可克服悬线的拉力.在混合联珠单球碰撞时,根据理论分析,选取大球和小球的质量比为27∶8时,演示效果较好.